Skip to main content
All articles

Sourcing & Orders

How to Measure the Usable Width of Openwork Lace Trim

Zhijin / All4LacePublished Updated
All4Lace catalogue photograph used as a visual reference. Confirm the actual sample, colour and construction before ordering.

A listed width can include a plain sewing edge, an open centre and projecting scallops. For a pattern piece, the useful decorative width is the part that remains visible after attachment; ask for a measured sample rather than treating a catalogue number as a cutting allowance.

Openwork lace width: attachment margin, holes and scallop tips

Lay the trim flat without pulling it. Mark the straight attachment edge, the deepest opening and the furthest intact decorative point. Measure at several repeats and note whether the outer tips alternate; a single widest point does not describe the continuous coverage.

Visible openwork lace width after sewing into a neckline or hem

Pin the exact trim to the intended neckline or hem on the real base fabric. Mark the stitch line and fold or seam allowance, then photograph front and back. Check whether the edge still lies flat and whether openings reveal the lining where the pattern expects coverage.

Width and repeat measurements to retain for openwork lace approval

Approve three dimensions separately: total edge-to-tip width, continuous visible coverage after stitching and repeat length. Add the measurement points to a dated sample photo and quote request. If the usable width is insufficient, revise the placement or choose a different trim before pricing the garment.

Discuss your embroidery project

Send the trim reference, garment location, required visible coverage and a marked sample photo to All4Lace.

Contact Zhijin

Continue reading