Skip to main content
All articles

Quality & Delivery

Embroidery Needles for Tulle: System, Point and Thread Compatibility

Zhijin / All4LacePublished Updated
Original selection schematic, not a needle drawing to scale or a test result. 1: machine-system compatibility; 2: point and eye compatibility; 3: finished trial inspected on both sides. The shapes do not specify a needle model.

There is no single best needle size for all embroidered tulle. First confirm the needle system required by the machine, then compare a compatible point and size with the actual ground, thread and motif. A supplier’s needle recommendation becomes useful when it is connected to a finished trial and a recorded machine setup.

Confirm the needle system before discussing size

A needle system describes machine compatibility; its size alone does not. The SCHMETZ industrial embroidery document lists several systems and application-specific versions. A household embroidery needle and an industrial embroidery needle must not be treated as substitutes simply because a similar size appears on their packaging.

Ask the embroidery team to record the machine reference and the complete needle designation. If several heads produce the same panel, identify which head made each comparison. This prevents a trial made with one setup from becoming an unsupported instruction for another machine.

Original selection schematic, not a needle drawing to scale or a test result. 1: machine-system compatibility; 2: point and eye compatibility; 3: finished trial inspected on both sides. The shapes do not specify a needle model.

Tulle embroidery needles: Separate the point, the eye and the size

SCHMETZ describes round and ball-point variants for different textile structures, while its embroidery document also discusses the eye and thread handling. These are separate selection variables. “Ball point” is not a guarantee against damage, and “fine needle” is not a complete specification for an open mesh.

Tulle embroidery needles: Separate the point, the eye and the size
VariableCheck on the trial
SystemCompatibility with the identified machine
Point and sizeGround yarn damage and stitch formation
Eye and threadFraying, breaks and stable thread passage

Identify what is actually damaged

Use a magnified view to distinguish a cut ground yarn, an enlarged mesh opening, a broken embroidery thread and a missing stitch. Mark whether the defect follows needle penetrations, a dense overlap or the edge of a motif. A bright hole in a backlit photograph alone does not identify the cause.

Compare face and reverse after removing temporary support as specified. A support film can conceal a small cut until it is removed. Retain the affected trial before altering the setup; the next version should be compared with that evidence, not with a memory of the defect.

Change one compatible variable at a time

Start with a known setup and a fresh compatible needle checked by the operator. Hold the ground lot, design revision, thread and support constant while comparing the intended needle change. Keep the full motif in the test: a few isolated stitches may miss the dense junction where the defect appears.

If the result does not improve, investigate other interacting causes such as stabilisation, design overlap or machine condition rather than continuing to change needle sizes without a record. Let the qualified machine team handle setup and maintenance. This buyer’s review method does not provide a machine-adjustment recipe.

Approve the result, then retain the setup record

Define acceptance on the finished panel: visible holes, cut ground yarns, skipped stitches, thread breaks and distortion each need a separate decision. If the panel will be lined, assess that combination too. A good-looking motif does not automatically establish that the surrounding net remains undamaged.

Does a larger eye always require a thicker needle? No: eye geometry depends on the needle design, so use the complete manufacturer designation. Can an approved setup be reused after changing thread or ground? Treat the change as a reason to confirm compatibility again, retaining both the sample and the revised setup.

Discuss your embroidery project

Send All4Lace the tulle reference, thread specification, motif artwork and a marked photograph of the problem. Ask for a labelled comparison of the proposed needle setup on the intended construction, rather than approving a needle number without a stitched sample.

Contact Zhijin

Continue reading